Customized slide stops?

[kahr360]

I’m not a fan of the slide stop on my PM9 it has way too many pointy corners.

If I find another slide stop for a good deal I’m going to take the grinder and dremel too it.

I was wondering do any of you guys have photo’s of your own customized Kahr slide stops, so I have some ideas to go off of?

[ripley16]

I don't find much fault in the stock piece. If it works I generally leave it alone.

[jwr]

I took a buffing wheel to the slide-stop on my CW9. It took the sharp edges off and feels much better but you can't tell by looking at it that it's not stock--nothing fancy.

[jocko]

go to

I’m not a fan of the slide stop on my PM9 it has way too many pointy corners.

If I find another slide stop for a good deal I’m going to take the grinder and dremel too it.

I was wondering do any of you guys have photo’s of your own customized Kahr slide stops, so I have some ideas to go off of?

karh tech section and hit on jocko's custom PM9. I did that slide stop mod with a dremel, took maybe 10 minutes. Even shortened the end of the slide stop, looks like a trigger pin now. Still easy as hell to take the slide stop pin out..

[kahr360]

karh tech section and hit on jocko's custom PM9. I did that slide stop mod with a dremel, took maybe 10 minutes. Even shortened the end of the slide stop, looks like a trigger pin now. Still easy as hell to take the slide stop pin out..

That looks good.

[jocko]

and

That looks good.

it truly is. If your a person who accidently hits the slide stop lever on a kahr, this mod will help alot. Cosmetically , to me it just looks so much sleeker and at the worst you can just ruin the slide lock lever and you just buy another one. Not sure how one can really ruin it other than not liking the looks of ones mod after he has done it. again once you take metal off, you can't put it back on, so modify slowly to get the results that you want

[gb6491]

I took a buffing wheel to the slide-stop on my CW9. It took the sharp edges off and feels much better but you can't tell by looking at it that it's not stock--nothing fancy.

Same here, I used a Dremel to knock down the sharp edges and corners on my slide stop.

Regards,
Greg

[jocko]

nice job, very custom looking also.

[gb6491]

Thanks Jocko
Regards,
Greg

[gb6491]

Same here, I used a Dremel to knock down the sharp edges and corners on my slide stop.

Regards,
Greg

Well, after having a buddy unintentionally lock the slide back while shooting my CW45 this weekend, I decided to get a little more aggressive with the reduction (somewhat following Jocko's lead here ):

Compared to an unmodified stop:

Regards,
Greg

[kahr360]

looks nice.

[jocko]

nice work and as u found out to a real no brainer to do.