Hogue Grips

[68blackbird]

Which one are you guys using on your CW9? All the ones I have seen say they are for .22, .380 guns?

[ripley16]

The Handall Jr. fits the P and C series. I use and like them on my poly Kahrs.
http://www.kahr.com/Grips/Kahr-Hogue...ubber-Grip.asp

[wagon]

The Handall Jr. fits the P and C series. I use and like them on my poly Kahrs.
http://www.kahr.com/Grips/Kahr-Hogue...ubber-Grip.asp

+1. I call it the "must have upgrade" for the CM & CW grater grips.

[Short Bus]

I like the Quik Grip size 2. It doesn't add bulk or the finger bump like some of the other grips.

http://www.tacticalinc.com/qwik-grip...-30-p-601.html

[ripley16]

I also use a Pachmayr grip similar to the Hogue. Either works well.

[KoolBreeze]

I went with the rubberized Talons.

[Short Bus]

I also use a Pachmayr grip similar to the Hogue. Either works well.

IMO that looks to small, here's a crappy pic with the Quik Grip

[nuke]

I'm considering the Hogue Handall Jr, also, based on input from a friend that has them on his CW40.

[ripley16]

The Pachmayr is on a P9. It looks like your pic is of a PM, so it would look shorter in the grip than my photo.

[Short Bus]

The Pachmayr is on a P9. It looks like your pic is of a PM, so it would look shorter in the grip than my photo.

No, my gun is a P9 also.

[ripley16]

No, my gun is a P9 also.

In that case I may have to look into the Quik Grip.

[Short Bus]

In that case I may have to look into the Quik Grip.

It's about 1/16" to big at the front of the grip (about the gap between the mag.), but to me it's not enough to mess with trimming.

[Chogers]

I just bought this one. The listing has a really good close up picture of the Hogue as well.
http://www.ebay.com/itm/320881062914...84.m1497.l2649

[vanbo]

+1 on the Hogue Handall Jr. (P9)... It made a huge difference in the comfort factor for me.

[Flincher]

Will the Hand-All Jr. fit the P380 or is it too large?? I'm considering making a sleeve from a bicycle tube, but if the Hogue works, maybe I'll go that route.