CW Night Sights

[gb6491]

to get back to the OP's question and mine Will the Dawson front sights fit a CW45?

Kahr lists just one sight, P/N: 034a, for the CW series and E9 in their parts list (actually they call it "unique to CW series/E9"):
http://www.kahr.com/DL/kahrpartslist.pdf
I figure if the Dawson sight fits the CW9, then it will fit the rest of the CW series as well..
Regards,
Greg

[Vincent]

Vincent, I like those sights. Who did you get them from?

If you read more closely those are not mine. Those are the ones sold by Dawson Precision.

The factory Kahr front sight I got is a blade with out the flange around the bottom and the rear sight is not streamlined like the one in the picture. Both of those pictures are from the D.P. sight.

[G2memphis]

Well I put off sending my slide in for the new night sights and now they are "temporarily" out. Anybody know how long before a new batch will be available?

I exchanged emails with a service representative Friday, 4/2/10, and he said they should be having night sights for the CW series available on the Kahr website "in about two weeks".

[bayoutrigger]

2 weeks... thanks for the info!

[jocko]

I agree

Kahr lists just one sight, P/N: 034a, for the CW series and E9 in their parts list (actually they call it "unique to CW series/E9"):
http://www.kahr.com/DL/kahrpartslist.pdf
I figure if the Dawson sight fits the CW9, then it will fit the rest of the CW series as well..
Regards,
Greg

I think your right, if it fits the cw 9 it will fit the cw40 and 45 ..

[rogerthedodger]

Has anyone installed the Dawson nite sites on a CW9. Easy to do?

[noslolo]

Looks great, how hard is it to remove the stock i sights?

[Vincent]

VERY easy to remove the front sight. Just break it off with pliers, sounds crude but it is how it is done.

Rear sight was a little harder but I pressed mine out using a machinist vice and a piece of key stock.....pretty easy. If you have a sight pusher it would be really easy.

[rogerthedodger]

I put XS big dots on a glock, was easy. The front sight uses a small screw from inside the frame, rear is in a beveled cut, held with 2 setscrews, then red stuff put around sight, dried in 2 hours. Is the Dawson similar for the CW9??
Roger

[Ljutic]

I'm really torn between XS or wait on Dawson. I'm a big fan of Dawson stuff, but I'm ready to drop the order.