My new P380 disassembly tool

[East River Guide]

I love my P380 but it always bugged me that it is harder to disassemble and pull the extractor or clean the striker channel than say my Glocks or a 1911. There have been some great suggestions here over the years, but I recently found something that helps with the search effort that results when your extractor pin flies across the room. Working inside a plastic bag is awkward, so here's my new tool:






Can you spot it? No, it's not the third-hand coat hanger tool, you need that too. It's the tape. We have an extra bathroom in the basement near my workbench and I used the tape to cover the shower drain. Now when I disassemble or reassemble the P380 slide I go into the shower stall before I mess with the cover plate. When things go flying now they don't go far at all!

[sas PM9]

I love my P380 but it always bugged me that it is harder to disassemble and pull the extractor or clean the striker channel than say my Glocks or a 1911. There have been some great suggestions here over the years, but I recently found something that helps with the search effort that results when your extractor pin flies across the room. Working inside a plastic bag is awkward, so here's my new tool:






Can you spot it? No, it's not the third-hand coat hanger tool, you need that too. It's the tape. We have an extra bathroom in the basement near my workbench and I used the tape to cover the shower drain. Now when I disassemble or reassemble the P380 slide I go into the shower stall before I mess with the cover plate. When things go flying now they don't go far at all!

ERG:

Pretty cool take down booth.

-steve

[muggsy]

Hey, while your in there you might even consider taking a shower. Just sayin.

[Nismo]

Or just stick a neodymium magnet on top of the slide.

[Kmckinnon]

Hope you close the lid on the crapper too!