Picked up my CW 45 today.

[TheTman]

I picked up my CW45 that I ordered from grabagun while they had them priced so low. So... I imagine now that the CM45 will begin appearing soon. I just hope this one will function with the 7 round mags.

[BEARDOG]

Tman Did your new CW45 pass Gregs "short rail" test?
I posted a reply to you about it in the other thread but don't know if you seen it.
http://www.kahrtalk.com/showthread.p...968#post306968

[yqtszhj]

Tman Did your new CW45 pass Gregs "short rail" test?
I posted a reply to you about it in the other thread but don't know if you seen it.
http://www.kahrtalk.com/showthread.p...968#post306968

Has kahr been sending pre paid labels and replacing frames willingly? Mine works flawless and I dont really want to send it back even it doesnt pass the test.

[Armybrat]

Has kahr been sending pre paid labels and replacing frames willingly? Mine works flawless and I dont really want to send it back even it doesnt pass the test.

Same here.

[Bawanna]

No for sure thing on the prepaid but probably so.
They do recognize the issue and are replacing the frames as needed.

If yours doesn't pass the Greg test I'd send it back. It should run even better. Greg had very good results with his and I know his ran very well before the frame swap. He reports it runs just as well or better afterwards.

[TheTman]

The metal starts rail starts about 1/8" to 1/4" behind the front of the frame. There is nothing loose.

AND, wouldn't you know it, I got a message from grabagun today, that they have CW45's in stock. I KNEW that would happen. They are about $90 more than the CW45 was, $373.24. Better grab one while you can if you want one.