OWB holster position

[Allen]

I'm trying to find a comfortable position for my CM9 OWB holster. At about 2:00 I have trouble sitting down as it jabs into the front of my leg. At 3:00 it catches on chair arms and door jams as I go in/out. At 4-5:00 it seems hard to lean back in a chair or drive in that position.
What position are others finding the OWB holster to be the most comfortable and easy to reach when necessary? Any suggestion to work on will be greatly appreciated.

[Bawanna]

I'm a 3 to 3:30 guy myself with a 1911. It just feels right. It's comforting when I lean back in a chair and feel it.

Just far enough back to aid with concealment and in nice grabbing range.

Years ago I was a cross draw guy and varied from 10 to as far back as 7 but I was skinny then and I think my arms were longer. Slower to get the gun ends swapped and aimed at the bad guy but not much.

Still a hundred times faster than pocket or down the pants carry in my book.

[RRP]

4:00 works best for me, but I'll be first to admit it is a poor choice in an automobile--especially one with bucket seats. Fortunately, I don't spend much time in a vehicle during my work day. If I did, ankle and/or appendix would be preferred.

[rowdy115]

I carry my CM9 in a little OWB leather holster at 2:00 position. It doesn't jab into my leg depending on what jeans I wear. A lot has to do with how the cut on your jeans is. I have lower waist cut relaxed fit jeans that hang a little lower on my waist and I can't carry OWB at 2:00 with those because the holster jabs into my leg when sitting (so I pocket carry with those), but I have jeans that fit a little snugger that I wear with my cowboy boots that ride higher up on my waist and I can carry super comfortable at 2:00 all day long OWB with those. The higher riding waist jeans moves the whole rig up higher and causes it not to jab into my leg when sitting. That's just my experience with it. Carrying OWB at 2:00 position is my favorite mode of carrying. Just something to consider.

[diablo53]

I carry mt pm45 at 3 o'clock OWB. I'm not a narrow fella and it doesn't hang on anything. Does your holster keep the gun high and tight to the body? Also, If you don't have a stiff(gun) belt your holster might not be the problem.

[shlike]

I carry OWB at 2:30-3:00. The key for me is to use a holster that rides high and tight to the body. For my larger carry guns I use High Noon pancake holsters, which are designed to ride high and tight to the body. These holsters are expensive, but well worth it IMHO. I can comfortably carry my Glock 19 and my Sig SP2022 concealed with very little interference. As others have pointed out, it is critical to use a dedicated, very stiff gun belt that helps keep the gun tight to the body. Here is how I carry my Glock 19 and Sig SP2022:

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]

For my smaller carry guns (Shield, CW45, CW9) I tend to use kydex pancake style holsters that also ride high and tight to the body:

[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]

[berettabone]

I'm trying to find a comfortable position for my CM9 OWB holster. At about 2:00 I have trouble sitting down as it jabs into the front of my leg. At 3:00 it catches on chair arms and door jams as I go in/out. At 4-5:00 it seems hard to lean back in a chair or drive in that position.
What position are others finding the OWB holster to be the most comfortable and easy to reach when necessary? Any suggestion to work on will be greatly appreciated.

For all of the reasons above, is why I prefer a clip on holster. It slides on your belt from belt loop to belt loop, which allows adjustment when sitting or standing. The tension screw allows for a smooth non-snag draw. The firearm comes out very easily. It's light, easy to clean, quick on, quick off. The clip is very strong. You can adjust the cant to about 15 degrees. I have a few of these holsters for different firearms. After using one, I will never purchase another type again. I use a 5 stitch nylon gun belt. Works very well for me.

[Allen]

Appreciate all the great information. First all, it sounds like a belt may be my main problem. And i probably need a lot better holster than Uncle Mikes, but I didn't want to put a lot into an OWB holster if it wouldn't work for me. I'll start with a new belt. With my mid-rif bulge my jeans will only ride in one place, very low.

[berettabone]

If you want a belt, that you don't have to worry about losing or gaining weight, the Wilderness 5 stitch belt may be for you. No holes...........I started using one about 3 or 4 months ago, and it works and feels great.

[Dbholfo]

Asked for link. Found it myself. Nice belts but pricey.

[diablo53]

Think about it this way, unless the cm9 is your only gun, the gun belt could be the least expensive piece of gear. It can be used with ALL of your IWB and OWB holsters for all of your guns!
Or think of it this way- If it's not comfortable, you may not carry. You have 0 chance of shooting someone to defend yourself if you don't carry your gun.
My advice, after trying everything to save money, buy the good stuff first and don't waste money buying junk that don't do what you want.
I have a leather "thebeltman" belt ($70). I got it for Christmas, and it's a huge jump in comfort over a regular belt. And I have a YetiPro OWB kydex holster for my PM45. It's an excellent concealable owb combo that is comfortable to wear.

[RRP]

My advice, after trying everything to save money, buy the good stuff first and don't waste money buying junk that don't do what you want.

Wisdom

[TheTman]

For something more affordable, I have good luck with Dickies brand wide thick leather work belts. The best ones seem to be found at Farm and Ranch supply stores, that also sell clothing, Atwoods, Orschelins, but I think I bought my last one at Walmart. I'm not sure if Tractor Supply has them or not. But they are usually less that $25, and have been comfortable for every holster I've used them with. My 1911 or 6" S&W 629 are the heaviest I've used them with, and they work out fine.
They are made to hang tool bags from, so holsters should be no problem for them. Not the dressiest belts in the world, but functional. I try to get the widest and thickest that will go through the belt loops on my jeans.