Thinking about refinishing my KAHR P9... Cerakote maybe?

[Roadblock]

This isn't really specific to any certain model, it's not a tech question either so it gets put in the "General" department.

I have a standard KAHR P9 I'm thinking about tossing some night sights on. While the slides ripped down, I thought I would have the slide blackened.

Was thinking about Cerakoting but the place doing the work also has the factory KAHR blackened finish available. I think I'm going to just do the slide and the back plate, leaving the trigger and slide lock stainless.

Which finish would you guys go with and does anyone has any pictures of KAHR's they had blackened?

[jocko]

both good the clc finish IMO is very very very durable, just like the glock tennifer finish. If in doubt flip a coin and never look back as both are excellent.

[1sleekMK40]

http://www.customizedcreationz.com/

CCR-REFINISHING

Might want to check these guys out before you make a decision...

[8th SPS USAF]

Refinish KAHR

I had CCR do my PM 45 in Urbon Camo. Slide that is, and

had mags in blk. Very nice job.

8th

[jocko]

indeed

This isn't really specific to any certain model, it's not a tech question either so it gets put in the "General" department.

I have a standard KAHR P9 I'm thinking about tossing some night sights on. While the slides ripped down, I thought I would have the slide blackened.

Was thinking about Cerakoting but the place doing the work also has the factory KAHR blackened finish available. I think I'm going to just do the slide and the back plate, leaving the trigger and slide lock stainless.

Which finish would you guys go with and does anyone has any pictures of KAHR's they had blackened?

leave the trigger system alone, best not to try to take that area apart. I would also leave the slide stop lever and trigger as is. U can polish both to a nice finish also, right on thegun. The kahr dlc finish is extremely durable. not sure you willgo wrong with either finish..